Recent content by 01swifty

hey all when i put the clutch in and hold it it loses pressure and have to pump it to get clutch back i have bleed the system with not change next thing i was thinging was changing the whole fluid any ideas on what it could be thanks

to the top

hey im after 2 sets of headlight brackets let me know if you have them thanks

yer its just the stock one i might check to see if it leaks it just shits me when it hits it

hey all my wifes car hits boost cut at about 5000rpm it has a front mount and a zorst even if i run it on low boost it hits it in 2nd gear and up any ideas on how to fix this cheers

i am a tinter and i would recomend you get a pro to do it well atleast the rear screen as it is curved and you need to shrink it the sides r easy i did a custom tint on my wifes starlet now if i can just find pics for you oh and try and find some1 to sell you some SUNTEK FILM thats wat i use and...

no one got any?

as it says im after a pair of quad headlight brackets to be sent to australia i might be after 2 sets depending on price and postage thanks

i hve no engine light on but i did have 1 on before and found out it was the knock sensor was not plugged in sence then it has played up would it be faulty?

ok my wifes ep82 starts runs but when you take off it will boost 1st gear then will not boost 2nd 3rd just dies and back fires and will only drive if you keep it off boost but if you pull over and free rev it then take off it will boost 1st but not the rest of the gears i had a boost controller...

how do you remove the hi-lo function when u install a boost controla?

i hooked this up and now it breaks down big time when it goes to boost any1 now how to fix this?

the top plug runs along the injector loom and is folded up it had new new motor put in it not to long ago i will jack it up tomorrow and have a look and see wat i can work out

yer i just cant see it lol and i have 2 plugs going to nothing and my check engine light is on and when i do a test it comes up knock sensor if i can see what the wire plug is then it might be that its not plugged in

just emailed them cheers man