Recent content by babu_rashu

  1. babu_rashu

    5e clutch kit

    Wondering what clutch set up ppl using in 5E turbo. I m using asco 5e flywheel (212mm) with exedy stage 2 ceramic clutch kit (4efte) My one around 320 hp. I can drive the car smoothly in low RPM, but when I push the clutch start slipping Badly, so Wondering what clutch kit ppl using in...
  2. babu_rashu

    Ep82 rear abs sensor

    Bump
  3. babu_rashu

    Ep82 rear abs sensor

    desperately need rear abs sensor for ep82 (both side) Part number--89546-10010 New/ used
  4. babu_rashu

    forged 5e setup. your opinions and suggestions plz

    I m planing for 5e too, I m going for weisco piston and Athena 1mmHEad gasket, what flywheel r u planing to use? If possible buy some valve springs..
  5. babu_rashu

    5E conrods and piston

    thank u very much for the info bro...
  6. babu_rashu

    5E conrods and piston

    i m planing for 1.2-1.5 bar boost with a TD05 turbo, can i use 4e clutch ? thanks for the reply.
  7. babu_rashu

    5E conrods and piston

    hello everyone.. recently planing for 5e. i have few quick questions * scat or pauter made 5e con rods ? what is the best con rod for 5e * what compression ratio is good for 5e. * what clutch kit and flywheel best for it? the answer would be of grate help to my build.:rockon:
  8. babu_rashu

    Newbie!

    welcm mate :-)
  9. babu_rashu

    WANTED Glanza EP91 MT Wiring Loom

    hi i am looking for Toyota Starlet Glanza EP91 MT Wiring Loom if any body has it please PM me thanks
  10. babu_rashu

    Huge update of CRD

    good luck mate :-)
  11. babu_rashu

    newbie from malaysia...

    abang welcome to TGTT
  12. babu_rashu

    Toyota Starlet Glanza EP91 Wiring Loom

    hi i am looking for Toyota Starlet Glanza EP91 Wiring Loom thanks
  13. babu_rashu

    newbi from ireland

    welcome to the club lad :-)
Top