I am in the proces of putting a 4age/gze in my glaza but i would like to reuse my original glanza gearbox with lsd and its mounts. I was told I could use the bell housing off a 4a or 4agze and mate it to the back half of the starlet gearbox. I want to know if this is possible, which starting...
Can someone tell me what timing a stock 5efhe runs please. I have my timing map done but I am thinking that it is a bit low. I am willing to post a pic of it. Any help is appreciated. I just want a basis or guildeline as in how much i could possibly run.
I haven't been on the DYNO but from using "My Butt Dyno" this is the best manifold I have used low to mid range. I have not turned up past 10psi as yet. But if my car feels so good on 10 psi as is now. I can only imagine how it will be when i double that. Takes absolutely no effort to move...
Yes Gorganl200 same radiator and fan I always been using. But i was previously using water. Now I am using coolant. I now set up my aem to tell the fan come on earlier but even with fan on it still rising. Before my temp guage would go to the bottom right corner of D (using automatic gauge...
Thank you so much I was wondering why it was sometimes the fan would be on at 84 and then yesterday after doing some testing it came on at 92
For some reason now in traffic I am seeing 92-98 degrees with fan on. I have in a TRD Thermostat which is supposed to open at 71 or 75. Pondering...
At what time does the temp gauge go up. Usually i see the temp around 80 degrees no matter what time of day but with this new build I am seeing it go to 84 85 and the temp gauge on the cluster goes up has me a lil worried. This is day or night if i rough up the car a lil on 10psi. I don't...
I have recently installed the ACIS manifold and following the advice of gorganl2000 and iFur i have used the vacuum canister from an evo which has a one way valve built in and connected directly to intake manifold the other end goes to a NA 3 port solenoid which then runs into the diaphragm...
Yes I am on a serious budget. I have head Pauter is the best but super expensive. And I Know scat rods call for notching of the block. These maxspeeding rods i recently came across but am yet to find anyone that has used any of them in any type of vehicle.
Came across these has anyone used them? Can't find any reviews online http://www.maxspeedingrods-store.com/Toyota-5EFE-connecting-rods-4-pieces-CR-TOY-5EFE.htm
MAXSPEEDING rods.
I was told that we can use the same clutch and pressure plate from vehicles such as the 20v 4age. Was also told we can use them from the 2zz-ge and that the same we we redrill the 4e flywheel to match the bolt patter of the 5e we can do the same thing with the 2zz-ge flywheel. Can anyone...
I had a 28r on my 1300 with a slightly ported head boost came on about 2700 rpm by 4000 had to be on at least 10 to 12 psi. and 14 shortly after all the way to redline. Turbos are very early spooling but I never got to turn it on to feel it flowing more air upstairs. My friend has a 28rs on...