Recent content by beanthecrackfiend

any one?

need standard turbo intake pipe from turbo to cone.the pipe with efi writtin on it.thanks my numbers 07500118222

bad news :( the geeza from the garage came down to have a look.took the plugs out and did a compression test ,cylinder 1 -150psi -cylinder 2 -30psi cylinder 3-30psi-cylinder 4 -150 psi.So he put a camera through the spark plug hole in cylinder 2 and there is a hole in the headgasket goin from...

have chekd lead today an its sparking fine when i arc it to the rocker box and doesnt appear to be arcing when its running.so i took it to me garage n they did a diagnostic test and the results were- ignition signal-intake temperate-turbo pressure bearing in mind im running aftermarker ecu...

will try that soon as.hpefully is that lead ,fingers crossed!will post asap.thanks

hi there.right first things first ive got a 96 glanza turbo just had fully recon engine from mr.engine witch included all gaskets,seals,bearing,rings and shims stainless mannifold speedvision ct9 hybrid,3 inch de-cat full stainless,avcr boost controller,g-reddy emange and front mount intercooler...

Well just got the car back from mot wich it passed .and have had a look under the bonnet and it looks to me like the bottom of the two gear selector cables is streched was just wondering which cable it is because toyota is sayin there is a gear selctor cable and a gear shift cable but i dnt know...

thats what i was thinkin but nt sure meself the mechanic said it was either not enuf oil or the wrong oil.but you say it was the cables for those gears on yours which would make a bit more sense !!how easy was it to fix n how would i go about it??thanks

ive got act 4 paddle clutch good i think up to 350 lbs.just spoke to me mechanic and hes sayin gearbox oil but nt able to check as its in for mot all day!!

Ive got a ep91 just had new 4 paddle clutch and lightend flywheel fitted along with full recon engine and new turbo so box and block has come out.Everthing was fine for about 5 mins n then it didnt want to go into 4th just felt like there was no gear there and finally managed to get it in after...

re Thanks mate but already read this one.Just need some to tell me where the pipes connect to.In lamans terms.Bit simple u see.

Could someone post a picture and/or instructions on how to fit rrfpr as i took mine off and in the process of me putting my engine back in ive lost my camera .So ive got a load of pipes but im not sure where they go!!!Also im havving problems when tryin to start the engine ie. the car is over...

r I ve got apexi avcr.So will i still need to use the solenoid aswel.I need photos don't i.Just guesswork enit.

r shit.Any idea witch pipe goes where???

arrr how do you load pictures??