Recent content by grant620

I have been working with HQ to resolve the instruction issues. Should be sorted very very soon. The instructions were updated from the "old" model to the one you have, which hasn't gone too well as there are functions on the new unit that (as you have found) aren't well documented! Sorry!

Do you have MSN or similar that we could chat on?

Basically the scramble is there to add boost to a setting that is already working. So if you were at 1.1bar on throttle and that was (say) 44%, and you had scramble set to 10%, then pressed the button... It would make the total duty 54%. If you back off it will run 0% duty, so adding 10% (or...

Hi David. The warning boost issue is correct. As for scramble... If you are flat out and running 1.1bar, then press scramble, are you saying the boost DROPS to 10% above actuator pressure??

Hi, Sorry to hear of your problems. As per emails, please be assured that we will get this sorted for you ASAP. We will update on here when we have tested the unit. It is very unfortunate that it seems we have had 2 units faulty on here in 2 posts! Over 120 of these are sold per month and the...

Hi there, Just read about your problems with your MS-IBC. From what I have read this sounds like you have a faulty solenoid or loom. We would like to get this sorted for you ASAP. You either have a faulty solenoid or a faulty loom - both of which we can send out to you, but it would be...