Received my new intake manifold from Keith earlier this week, and what a lovely bit of kit! Keith was helpful, clear and precise from start to finish.
comes highly recommended! : )
you need 2 bars, about 3 - 5mm thick steel, the width of the seat, and a welder.. if you look on the bottom of the seats there is 4 fixing holes, 8 or 6mm bolts i think..? drill em to fit, then weld the bars to the rails.. hope this helps!
Hi guys, as some of you may or may not know i am Dave Burwash's nephew, after much boxing up and sorting stuff out we have finally got round to getting some of the old tmd stock on ebay, its all brand new unless stated otherwise. grab yourselves some bargains ;)...