Search results

  1. Fez

    Error code 41 - 4 wire TPS

    Hi guys, Recently converted to a 4 wire auto TPS on my Glanza which is running a eManage Ultimate. Car puts out error code 41 when in diagnostic mode. Have any of you experienced this before?
  2. Fez

    Wiring in 4 wire Auto TPS for eManage

    Hello, Can anyone help me out with wiring in the 4 wire auto TPS? Car is a 96 Glanza - manual running a eManage Ultimate. Thanks!
  3. Fez

    Head Gaskets

    Hi guys, Advice on compatible head gasket numbers that can be used on the 4EFTE please? Blown gasket and part no 11115-11071 isn't availabe here :/
  4. Fez

    Fuel Pump

    Guys, can someone please advice me if a stock 4efe fuel pump would work for a 4efte on a Glanza? Toyodiy shows that the same part number works for the EP82's but not so for the 91 :/ http://www.toyodiy.com/parts/xref?v=J_199601_TOYOTA_STARLET_EP91-AGMQY_1902&s=2322074020
  5. Fez

    Plug silo oil seal part number

    Guys, would someone be able to tell me if the part no 11193-16010 will fit my Glanza? I am looking to source replacement seals and this is the part number showing with my local vendor
  6. Fez

    Starlet Meetup - Sri Lanka

    Hey guys, The Starlet Club in Sri Lanka had a meetup over the weekend. You guys can check out some pics at https://www.facebook.com/chathika.liyanage/media_set?set=a.772769006164098.1073741931.100002930166521&type=1&pnref=story :rockon:
  7. Fez

    EP91 Door handle

    Guys, I need to replace my passenger side door handle which broke off. Would any starlet handle fit the Glanza? Appreciate the input.
  8. Fez

    Glanza ECL - Diagnostic Mode

    Guys, is this how the light should flash when the car is in diagnostic mode and means no error codes? http://www.youtube.com/watch?v=gaotlxxTw2k&feature=youtu.be[/URL]
  9. Fez

    oil light and gauge reading

    Guys, I replaced my o2 sensor last evening and on the drive home after a bit of boosting the oil warning light came on. Stopped and checked for any leaks etc and found none. Oil levels were perfect too. I later found that there are two wires leading from the oil pressure sensor. One of these...
  10. Fez

    Any members from Paris on here? :)

    Will be in France later this month. Would be great to meet up with a fellow enthusiast.
  11. Fez

    Keeps cutting out, searching idle and reeks of petrol

    Ok guys, here's the scenario. The stock intake mani of my 96 Glanza was covered with grime on the inside, so decided to get it cleaned after consulting with a few members on here :) also got the petrol pump and filter in the tank cleaned up as well. Since I was short on tools and proper...
  12. Fez

    Shadow brand gauges

    Hope im posting this in the right section. Do you any of you guys use the Shadow brand gauges on your cars? Would you recommend them?
  13. Fez

    Pick between Yokohama ES100 and Yokohama A Drive PH1

    Guys, any of you used/ have experience with the above tyres? My current Roadstones are on the way out, and looking at options :) Tyre size is 195x50x15 and looking for a balance between good mileage off the tyres and also decent enough wet handling. Mine is a fully standard setup daily driver...
  14. Fez

    Check Engine light when boosting

    Guys, appreciate your advice on this. I'm running a stock setup on my glanza. All factory stuff except for the magnecor leads. My turbo started spitting oil through the blow off valve and is about to be replaced. I had the check engine light come up all of a sudden today on my routine...
  15. Fez

    Stock CT9 Turbo for '96 Glanza

    Guys, looking for a stock CT9 turbo in good condition to replace mine which seems to have had it. Thanks
  16. Fez

    Toyota Genuine Fuel Filter part no for Glanza

    Guys, I purchased a fuel filter which had the part no mentioned on the box as 23300-19395. However I saw when I got home that there is a sticker on the filter itself which says 23300-11060. Could this be a case of having the wrong item in the box? Appreciate your advice, thanks!
  17. Fez

    Need help with part numbers

    Hello, My timing belt is due a replacement and I would apprecaite if anyone would be able to tell me the original part numbers of the below. Cam Oil seal Crank oil seal Timing belt bearing Thank you
  18. Fez

    Fogs and park lamps work, headlamps wont :(

    Guys, having an odd problem here. I used the car after it been parked for a day. (it was parked under partial cover and we had severe rain last night) This afternoon, I fired her up and (a) the a/c would not work.i.e, the engine revs go up and fan kicks in, but the air wont come through the...
  19. Fez

    Whole car shudders

    Hi guys, I was on a drive on some open roads over here and experienced a strange shudder through the whole car once I was hitting around 90 KM/h. Could anyone be able to tell me what could be the cause please? There is no problem on low revs/ speeds, just when on a higher speed. I'm on a...
  20. Fez

    Gearbox crunching and not smooth

    :confused: Hi guys, My car is a Glanza V and I had new clutch and pressure plate fitted two weeks ago. This morning on my daily drive to work, I noticed that it was not falling into gear smoothly. That is I have to really push the stick into gear and also theres a grinding noise when tyring...
Top