Search results

Im using a genuine FPR by Fuelab. Im not sure if it is because of the small return line

i am running lean after replacing my stock FPR to an adjustable FPR by fuelab. Issue 1 After placing the new FPR. Pressure is automatically set to 60psi, and we are unable to lower it down by adjusting the screw. (could there be a restriction along the return line as the pipe diameter is...

I found the culprit. Its the fuel return line. But i have found a new issue

Hi WeeJohn, I am using a Honda water temp sensor, base upon the reading checking it physically it seems ok. I just dont know why my engine stalls after revving it up on Idle or even during braking when running (even my foot is on the clutch or even putting the gear to neutral.) i dont know...

Hi GT folks, I know there had been several thread in this forum regarding eratic idling, etc. I have already read almost all of it since i started experiencing this problem last 2011. Here is a short information/history about my engine. in 2011. before i fully modified my 4efte engine i...