Search results

look greats some nice pics ,thanks phil must say that manifold came out well with the side exit exhaust

3 inch side exit exhaust also in the making

few little upgrades on this glanza hopefully can squeezse some more power out of this [/url][/IMG]

nice good to see :)

how many liters does a coolant system take with a half rad on a glanza from fresh built ,any ideas

why the need for 2 fuel rails in that glanza ?

im sill doing stuff phil yes just doing a custom jobby on a lads car at the minute [/url][/IMG]

give chris a link to a place in newry lawd ;)

still alot of toyota lads that are still around but mostly in groups on facebook due to getting the banns here lol ,few of the old members are rebuilding the cars back up ,,need to get them back on the site get some banter going again lol [/url][/IMG]

some time to run up there what manifold you got on the bad boy some flow from it :)60ft times is great for that track lad

full of greatness this thread :)

good job to Dylan east 12.3 standerd rev limit few upgrades he go into the 11s soon ;) richard teggy what can yea say some job

good ptfe gasket from the head to intake does a nice job on dropping temps due to heat soak i try and tested in

heat sink from a computer is it lol ,just off topic krissy b had a standerd intake before think it was cut down and rewelded cant seem to find the picture of it any one have ?think he sold it on few year ago

oh i gain some boost :)

john the middle wire is signal yes :)

tasty car bishopscourth 22nd should run well

cast iron can be tig welded with the right filler rod ;),,,but theres a process to it heat etc and the way it cools down

i know there was a thread about this cant seem to find it but can i hot wire in a apexi 3 bar map sensor were the factory one is ?

done all ready