Search results

Yeah that's what I was thinking mate. I have already brought a bottom end and had it ported to 74.5mm for the Pistons and notched for the rods. Thought whilst I'm down there I may aswell go all out. I had it looked at by an engineer and had a compression test done and one of the cylinders where...

Am new to the site and only recently got my Toyota glanza. Brought it off a friend with the bottom end gone. Was just looking for some advice on which is the best route to go down now ? I'm thinking forging it but not sure on what's required. Any ideas guys .? So far the spec list for the car...