Search results

Hi all, Does anyone know if the rear suspension/top mounts are the same on ep82 and ep91, also the UK non turbo variants. Mine are rotten. Thanks for any advice

Hi all, I'm after a set of rear strut tops for the rear suspension. If you have rear suspension that's complete and in good condition get in touch. Ep82

Hi all, Does anyone know what CV joints I need for my MK1 gt turbo? It has abs but is non LSD. Listing 2 different sizes. 23/23 or 23/30 Thanks in advance

Hi, I'm currently running a mines ECU on a mk1 GT and I was just wondering if the diagnostics will still work if I bridge the terminals in the diagnostics port. Thought better to ask before I tried it. Thanks in advance

Hi All, Just started experiencing problems with my heater. It's a mk1 GT. The heater will switch on and off on its own and there is a burning smell??? I think it could be a resistor but I don't know if it's changeable or where it's located. The blower still blows hot air so I don't think it's...

Hi All, Just noticed there may be a problem with my oil temperature. At warm idle the oil temp is usually around the 80 mark but as soon as i go down a motorway with my foot to the floor it shoots up to between 85-90. Once it idles again for a few mins it drops back down. This could be normal...

Hi all, I have a starlet gt running the following mods. FMIC, decat, aftermarket exhaust manifold, HKS actuator, powerflow exhaust. running airfilter in stock position, HKS SSQV. Problem is i've noticed oil coming out of the compressor side of the turbo where the intercooler hot pipe...

Hi all, I've just bought a mines ecu for my mk1 and wondered about the safety aspect of running 1 bar. I'm running a FMIC, Decat, HKS actuator, aftermarket manifold and exhaust system. i'm running 10.5 psi at the moment. would i need a rrfpr or can you ecu up the fuel to run a bar safely? I...

Hi All, Looking for a mechanical speedo converter for an EP82, the kind that screws into the gearbox. Thanks

Hi All, Had problems with a snapped speedo cable. Thought it was a straight cable from the cluster to the gearbox drive but it has a speedo converter on it and there is a 3 inch cable from the converter to the box. this is the one that has snapped. Where would i get this small cable from? if...

Hi all, My engine management light came on today and code 42 speed sensor was displayed. my speedo isnt working at the moment so i know thats the problem. The question is would this alter the cars performance? seems down on power. thanks