Search results

Hi All, My 92 EP82 came with the Reacro interior. The front seats have seen better days. They have adjustable thigh support and the headrest are solid not netted. Does any one know if these seats are similar to the Recaro LX or LS seats. Also, would the parts on this site...

I am getting an ECU diag code 12 and the engine brakes up on high rpm under load. It gets worse as the day gets hotter. The last time something similar happened it was the distributor. Something about grounding in the distributor. I had an extra one so I just swapped it out. The only one I...

This used to happen to me going from 3rd to 4th. After a while I realized that the car was shuddering really badly. When my mechanic checked the clutch some of the springs had popped out the the metal on the clutch was cracked. This has happened to me with two different clutches. ACT and...

Yes, I know R12 is banned, but I am not in the UK. I am actually in the Caribbean. Its banned here also but still being used.

I ran into the back of another vehicle and I need an A/C condenser for a early 92 EP82. Its the condenser which has the R12 gas fittings not the 134.

I want to change the door hinges on my ep82. Must I remove the fender or can it be done without removing it. Also, if the fender has to be removed, is it a simple process? Thanks

Grey plastic valve at the left end of the intake manifold held in with two bolts. One of the ground cables is held in by one of the bolts. There is a two wires harness plug plugged into it.

So Kon, you are saying the the water chamber does not have anything to do with the rpm of the vehicle. Because there is also 2 vacuum lines which is attached to it as well. I have already changed the idle valve and all temp sensors and checked vacuum lines but it makes no difference. I will...

HI, Does anyone know what the bit at the bottom of the throttle body attached with the 4 screws do. I have been having so idle RPM problems for sometime now and I have narrowed it down to the throttle body. Was wondering if it had to do with temp and idle speed. Regards

The car is not quiet stock, I am running an Emanage Ultimate. I reconnected the stock computer but no change. Yes, I have adjusted the idle screw all the way in. It only brings the idle to about 1400rpm. Oh, forget to mention fuel consumption has increased.

Ok, I am getting high RPM on idle. The car idles between 1900 - 2100 RPM. Sometimes it my drop to about 1100 for a while then goes back to about 2000 (no set pattern). Was driving very aggressively up some very hilly and winding roads and when I got to my destination i noticed the problem...

Does anyone know the A/R of the CT9, mainly the turbine size. I wish I could do a search on the site but I cant use words like ct9 and a/r. Is this ever going to be changed??

Hi all, my turbo bearings are shagged. I can get a CT26 rebuild from a friend but I need to know if the bearings will fit the CT9 turbo. Thanks

What does it look like.

Can someone tell me where the compressor clutch relay for the A/C unit is located in the EP82.

Can someone tell me where the compressor clutch relay for the A/C unit is located in the EP82.

Has anyone installed their WEPR ct9 power up kit. If so, I am interested in knowing what difference the kit makes other than preventing boost creep.

Hi Folks, Can anyone tell me what is causing my A/C light to flash. I turn on the A/C, the compressor comes on for about 5 seconds (does not cool the car) then shuts off and the light begins to flash. You help would be appericated.

Hey Sascha, What kind of power and/or response gains should we expect from this kit.

Ok will try that. Thanks