Search results

hi guys need bit of info on fitting rear strut brace. how do i fix the strut brace to the two studs on the coilovers? because there r two fake raised threaded bolts in the way. what ways have u guys got past this? i was thinking of making sum spacers so came 2 the same level as the fake bolts...

hi guys can any1 help? ive just finished working on my glanza all ive done is change the clutch and fit coilovers on it. just went 2 try it out on the road and found ive lost all boost. i cant c what ive done 2 lose it, i disconnected my battery, but wud this interfear with the boost controller...

hi guys, im fitting my panhard rod and noticed the bush on the adjustable side is a lot smailler diameter than the standard rod, and wont fit the the fixed bolt on the axel. are all the adjustable rods like this? ive put lots of grease on 2 help it slip on better but thats no good, how did u...

does anybody know where i can find setting up instructions 3 this ive installed it all but not sure how 2 set up high and low boost thanks 4 ur help

hi guys just installing my HKS EVC 4 and was wondering which position the switch on the back is ment 2 b in. there is a SW position or a PO position which 1 do i need 2 put it in thanks 4 any help

do i have 2 use 4mm vaccum pipe for 1 of the ports, wud it b alryt 2 use 6mm pipe and hose clamp it. plus wud it b alryt 2 run with out the inline filters 4 a while untill i buy sum. thanks again

i have just bought a HKS EVC 4, im gonna install it myself but was wondering if any of u guys have come across any installation diagrams or have any pics of ur own installs. i have 1 pic off a friend of the plumbing but cud do with a few more wiring and plumbing. if u cud help wud b great. thanks

hi guys i will soon b putting my glanza back on the road have had it in my garage 4 couple off months now modifying it. im gonna take it 4 a rolling road session but b4 i go was wondering what u guys think about what bhp i wud b hitting, ive put on 8.5 magnecor ht leads HDI FMIC decat...

im new 2 turbo cars and dont know the complete ins and outs of them. but was wondering what the actuator actually does and how 2 adjust it cud any1 give me a gd discribtion of the actuator many thanks

just started up the starlet again and ive sorted out the high reving was a vaccum leak but now there is a constant knocking noise like timimng is out ive fitted a new blitz access ecu cud it b sorting itself out any ideas thanks

have just started my starlet up 4 the 1st time since modifying it, have put a blitz access ecu on it a adjustable actuator, new mani and decat, HDI fmic moved the air filter 2 the front. but when started it up it constanly revs at 3000 rpm and the boost gauge is reading -0.5. im new 2 this and...

hi was wondering if any1 cud help me? i recently bought a hks evc 4 of a friend he had smashed his car and saved a few things, i bought this of him but didnt know much about them. i have just come 2 try and fit it and found that there is no solenoid. does anyone know if i can buy this seperate...