Search results

likely a typo, pretty sure they are wossner pistons.

yeah it quite low, but it does'nt scrape on the speed bumps and on spirted drives mate so am happy.

the welds still needed cleaned and tidied up in these pics, 2.5" all the way with a back box cut in half :-)

Il stick mine up later duncan, cant figure out how to do it on my phone.

Sorry I simplely miss wrote it a smoothish finish, mine were glass beaded. Sorry for the confusion.

well am with you skalabala, ive used numerous raceheads over the years and had good gains from them. that ruff bumps on the head will do sweet f all realy, air will be spiraling through the maniflow to the head anyway. Do u realy think that tiny rough patch makes a difference? the king of all...

With good fuel and tune, around stock cr u will be fine bud

U wont get any problems polishing intake side.

Speedvision.cps is where u get them. For the price there not bad. Thats if u can get them to fit.

Think it animalgt off here's.

x2 very knowledgeable guy, only guy i trust with my cars.

Am still here just cant be arsed posting, as every thread turns into a debate/rant about whos right. To many people copy and paste from google etc.

x2 but if u want the best theres a certain someone in greece

its not road legal sizes mate, wheres the boarder? its not the right shape, the letters look to be too close to the sides of plate, and its at a angle that would give off glare. the car should not have passed a mot with a plate like that to start with. taking them to court will likly see you...

pm me ur bank details bud, and il send you some pennys;) any pics of that turbo?

How come every thread I come in to now adays is a debate? to much people copying and pasteing from other sites etc. am sx turbo on this one

lots and lots of chicken and turkey and milk protein mate, if you have to take supplements to gain size/strength your not eating enough, supplements are a booster in my eyes. bulkpowders protein is amazing quality for the price. i eat 6000 calories a day but am 21 stone haha

Didnt realise it was that pipe that blocked mate, it will never happing again if you fit a magnaclean Though. I have never seen that pipe block in allmy years.

3 bar? These boilers arnt built to take that pressure. At 2.5 bar a warning light will come on( flashing red light I think). You should lower it to 1-1.5 bar. Also u let the pressure out ur expansion vessel? Down to 0.5bar? When the boiler was hot or cold? Also if its blocking pipes you should...

A new oil and water pump