Search results

I'm another long term member who remembers the different reicarnations of the site although I never was much of a poster. 4 Starlets later.. who knows maybe a 5th one day. Still miss my 1st one though, NA conversion. I'm still on the hunt for the video of the 2 starlets donuting to Push -...

Sold!

Weclome mate. I'm over in Barrhead so not too far away either :drive:

Got my EMU mapped the other day but i'm having trouble starting from cold. The car will start each time but cuts out almost immediatly. After 5-10 mins of starting it it will then idle i.e once there is a bit of heat in it. Any chance someone could look over my map and see if there is...

Nah at the fly after Russ's calculation. Thats with an EMU and 460's. Still got to sort a couple of issues: Won't idle with the headlights on Won't idle when cold

Another thumbs up for Russ. Spent a few hours sorting out my car and ended up with 245bhp @ 1 BAR.

Craig Is trying to get me to go too but I may still not even have my car mapped by then.

RIP #58 Sic! I wouldn't be surprised if Colin decides to retire now. Rossi won't but he must be in some state.

Have the 550's gone?

PM sent :)

Interested in the emanage. Do all the EMUs need the injector box?

Terrible news. My thoughts go out to the family.

Are you all using a manual fan switch?

Sold :)

bump When wired to the handbrake switch this can be used as launch control.

Got to be the quickest sale ever! :)

For sale: Apexi SAFC with stand/mount. Item Condition: Used but Excellent Condition Price and price conditions: £100 Including Postage within the UK. Extra Info: A piggyback fuel computer used to alter the air/fuel ratio. Instructions can be found here...

For sale: Bee*R Rev Limiter Item Condition: Usec but Excellent Condition Price and price conditions: £100 Including Postage within the UK. Extra Info: Used to set a lower than factory rev limit. I had it fitted to my old Celica GT4 and it was a good laugh at times. Good bit of...

Not you again lol

I'm only going by what I've been told the spec is so will dig a little deeper into that Chris. The SAFC was purely as a temp measure until I get a powerfc as I already had one laying about going spare. Thinking I might just wait and get all the remaining bits in one go and run 1.5ish BAR...