Search results

Great stuff :) well preped car thats been allways getting faster and faster

Was taken off youtube shortly after it was put up

Just make sure you clean the filter out with carb cleaner before fitting it. Should be fine and if its a bit slow to start off the petrol will lube it up and will work fine after a short time

Only in Ireland LOL

If your gona be pushing it at all hard, go for the Redline shockproof. Shockproof blue would be ideal http://www.redlineoil.com/product.aspx?pid=43&pcid=8

Its a fake, real hks logo is in black not silver. Check this pick taken from HKS japan site

Cant drive it down to get some milk though lol

Looks like something metal managed to flow into the head and bounced around inside the head. You can see the valve is all pushed inwards towards the cyl passably cuase by the metal been forced against the valve trying to get iv with vacuum and boost

Have you check the clearances on your valve shims with a feeler blade?

As the guys said, thoses results are fine. If you want check the bearings get your sump off

You can visualy check it first (build up of rust from water), then test it by dropping it into how water (should ideally be 80-85deg) and see that the thermostat opens fully

Dan get the guys below to throw a rail together so you can get a price and throw up a pic. Pete

Sounds like a low coolant level or a stuck thermostat

This happend me and i cut away at the casing the help the wire, and managed to get about 5mm of wire. Enough to let me soldier the broken wires together

There's Tein, but there not cheap. Sure you can pick up a second hand set somewhere

AEM are one of the best wideband's available with a separate 0-5v wire for data logging

I know a guy with one on his car in Dundalk, the car is for sale but not sure if he'd sell the de-cat separate

If you are doing some racing/drag then look into getting some shockproof blue (smurf blood)

Yes the Power FC has launch control in the Pro models, EP's not on pro list Allows you to set the revs you want to launch at and the foot to the fool and bounces of your setting untill it reads wheel speed over 10mph and then it removes the rev launch limit.

Starting at 12.5 and working its way along 12 and 11.5 and ending at 11 AFR Check this link for Lambda to AFR http://www.tatech.fi/cms/uploads/Lambda_vs_AFR.pdf