A242E Diagnosis codes! A Guide!

Paul_JJ

Member +
Before you start the Diagnosis check your battery as Low Voltage would give an Error Code for an Automatic Gearbox even if your engine will starts OK.

Make sure the O/D is ON - while the engine is running!

Make sure the engine is OFF.

Connect TE1 and E1 on the diagnosis connector.

Put the ignition to ACC.

The O/D light must flash 2 times per second - that means everything IS OK.
If you have an error code it would give you a code which would have 1.5 Sec pause in between the digits (2 digits), if you have more than 1 error code - than you will have 2.5 sec pause between the codes. You will always have the smaller number first in case you have more than 1 error code!

To clear the codes remove the EFI (15A) fuse for 30 sec!


CODE 42 - Speed sensor, short circuit
CODE 61 - Speed sensor number 2, short circuit
CODE 62 - Electromagnets on the Valve number 1, short circuit
CODE 63 - Electromagnets on the Valve number 2, short circuit
CODE 64 - Electromagnets on the Torque Converter, short circuit

The test will only show Electronic Faults (Sensors) of the Gearbox it will NOT show any mechanical fault!
 
Top