its on a feild harness mate, only think i had to do was quickly rewire the stock map sensor wire as it had split. but its all 100% the same as 18months ago when it ran perfectly.
im thinking the jumper settings are wrong, but i can see where the fault would be as ive triple checked it all.
the emanage does seem to be being gay with ignition signal. itll read fine but then when i use launch control it will throw the ignition reading out by around 180deg
read around +30 then will read about -160deg but this is a diffrent issue as neither timming reading causes knock or affects the map in anyway. & it still cuts out over 2000rpm on light throttle.