If your going to press the hub flange out of the bearing, chances are the outer bearing race will pull out with the flange. Basically the wheel bearing will need to be replaced when changing the hub flange.
Just be carefull when taking it out. As its a new bearing. It may press out all as one. But it might not its 50/50 bud. Just use loads of wd40
I'd put money on the fact the bearing will split, the force required to pull the outer bearing race off the flange will be greater than the force required to pull the race out of the bearing case, WD40 wont help you much here. Get yourself another wheel bearing mate, you'll be glad for it. The bearings are the same for both EP82 and EP91, so should be easy enough to get hold of, if it helps the ADL Blueprint bearing kit part number is ADT38227.
right guys, this seems too have been sorted now
got the wheel bearing etc out ok without damaging it, n all when back together nicely
took a little drive n no grinding etc
so thanks for the advice etc guys.
Fantastic Dan ! Least its all sorted now mate.
iain, forgot too get a pic fo the brake disc for you mate, will do it one evening this week as been told could caus brake too crack from the inperfection but wont hassel you too sort it just see what ya can do matey
thanks
dan