How to get lunch control to work on E-manage Ultimate. *

Discussion in 'Electrics / ECU / Diagnostics / ICE' started by gttuning-glenn, Jun 18, 2008.

Thread Status:
Not open for further replies.
  1. gttuning-glenn

    gttuning-glenn Registered User +

    This is to put the lunch control thread together for the resolved area, this was achieved with the help of alot of people, thanks for everything.

    Ok this will be a short couple of screenshots showing the settings needed to get this to work. All of the info is from the The Official EMU Tuning & prob thread!

    To get this to work you need to set the 4EFTE ignition type as IGNITION SIGNAL instead of the usual RPM SIGNAL. shown below
    [​IMG]

    Next step is to set the ignition cut settings. Go to the IGN tab:
    set your start and cut rpm and put a tick beside start to retard ignition for the lunch.
    [​IMG]
     
    Last edited by a moderator: Jun 26, 2008
    1 person likes this.
Thread Status:
Not open for further replies.

Share This Page