NZ PISTONS ON A 4EFTE BLOCK

[dac69er]

Well the cost at the machine shop isn't really high. Here they are quite reasonable and well the guy who does the machining is a friend so its not going to cost too much. That's why I ended up going the oem root. Spares are easily available if something breaks, and well...... The cost is way way way lower with oem. ... If it costed anything near forge then I would have definitely went forged but right now it cost just over a tenth which I can easily afford.

just bare in mind that if you snap a rod then the block is scrap and that isnt easy to machine out

as long as you dont push the parts beyond their limits, you will be fine.