Removing & Reinstalling the Instrument Cluster

Jay

Admin
Step one: Move steering wheel to lowest position and pull both indicator and wiper stalks down out of the way too.

Step two: There's two star head screws holding the dash surround on. Unscrew them and pull the trim forward. It's only clipped in at the bottom. Disconnect the mirror switch as well then carefully manovuere the dash trim out of the way.

brakepadsanddiscs2403ct1.jpg


brakepadsanddiscs2405wk6.jpg


brakepadsanddiscs2407tf5.jpg


brakepadsanddiscs2408zt2.jpg


Step three: Remove the top centre bolt and the two lower screws (one at each side) to release the dash unit itself.

brakepadsanddiscs2409ir1.jpg


Step four: You'll need to disconnect the connectors at the back of the cluster. Attack from the left side as you can get your paw in behind it easily.

1137.jpg


Step five: Hold your trophy aloft momentarily in a world cup style moment of glory then set it carefully to one side for modification.

1138.jpg


Here are the connectors :

1139.jpg


Note: You will also need to unclip the speedo cable!

To rebuild just reverse the steps above!

PS. This guide was written using an EP82 but it's close to the same procedure for you Glanza girls.
 
Top