Autometer Boost Gauge Fitting

Guys, are any of you running a boost gauge that uses a nylon boost pipe opposed to a rubber/soft plastic one.

My Autometer gauge doesn't have the normal sized outlet on the back, which allows you to you run a pipe from the gauge to a t piece in the bay, then onto the TB....Its got a tiny ass outlet with a nylon boost pipe attached which is obviously way too small to connect a T piece to. Any ideas of how to get around this?

So basically I need that rubber connector in the first pic, to connect to the T piece. Also any ideas where I could get one from and some new vacuum line?

http://www.mikefordm...uge-mustang.php

Thanks

You will need to use a piece of AN dash 3 silicone hose most speed shops sell this hose if not you can always try eBay

Can I use that straight some the nipple of the gauge or will this go from the nylon pipe to the t piece?

Djaniero said:

Can I use that straight some the nipple of the gauge or will this go from the nylon pipe to the t piece?

Click to expand...

On my car I have the silicone hose connected to the gauge and the nylon pipe connected to the silicone hose