Levin final drive

Jay

Admin
Not that I've done this myself but from what I remember it will involve involve opening both boxes and comparing which components are compatible. Ideally you want the output shaft and ring gear to swap across. Over the years I've heard of a few swaps getting interesting so measure everything. I've yet to get 'hands-on' with any of this malarkey though.
 
cant you just swap the bell-housing and run the box in its entirety?....i've heard that is what was done in the past

i think some needed to be drilled and tapped to hold the starlet gearbox bracket/mount

simple and easy i guess
 
Top