5E in and running...

Was bored today so got round to finally getting my engine in and running.

Experienced a few issues with some wires but finally got my ecu wired in aswell.

Anyway Fully Forged 5E engine with TD05




out with 5 speed lsd in with 6 speed, trying to find an lsd for this box


tein adjustable shocks


blitz front mount


alloy racing rad


Whiteline rear anti-roll bar


Cusco lower bar


3 Way rear bar


Side exit exhaust


cleaned engine bay up a bit


got it in


cooler on


finally done just before it got dark



Got the dta ecu wired in and stripped the interior while i was there, but just discovered an 82 steering column is different to the 91 so the wheel doesnt reach the rack minor problem anyway it runs so hey

not bad well done ,question the crank pulley design whats it for

its running a dta ecu with ford coil pack and cam pick up on the sump runs back to ecu

Looks good. Where did you get the engine from? A Silver Quadlight by any chance?

Idrees said:

Looks good. Where did you get the engine from? A Silver Quadlight by any chance?

Click to expand...

ditto... £2400 on ph.. bargain tbf

Yeah, stupidly cheap.

i bet that will go like a rocket !!!

looking good budy! using the ford edis system?

yeah dude it was from the quadlamp! Got a 7 hour train down there and drove it back 3 n half hours ended up paying 2000 for it, paid 1000 for glanza and sold quadlamp for 1800 standard lol. Ended up pretty cheap i think.

Never seen anything like the ecu but it works well with the setup and yeah the ford coil pack n pick up.