dark_knight
Member +
ecu ground
i tried the +12vdc switched feed (pin7 on conn3) Texx but engine didn't go out. i have to admit i didn't wait longer than 5 seconds as i was afraid something may be going wrong and may fry my ecu/engine but yeah.. i will try the ground, although there's three of them (pin13, pin24 & pin26 on conn1) so does that mean i take all out or just E1..?
i tried the +12vdc switched feed (pin7 on conn3) Texx but engine didn't go out. i have to admit i didn't wait longer than 5 seconds as i was afraid something may be going wrong and may fry my ecu/engine but yeah.. i will try the ground, although there's three of them (pin13, pin24 & pin26 on conn1) so does that mean i take all out or just E1..?
Last edited: