boost gauge fitting

C

CaL

Guest
now il go through this of how to fit a boost gauge

you will need

1. 3+feet or vacuum tube
2. 1 T-peice
3. boost gauge(of your choice)
4. 52mm-60mm gauge holder-(bracket)
vacuum tube and t-piece can be bought from local motorfactors

i bought a TIM 52 mm gauge off a mate for £5 with bracket and fixed it onto the bottom of the dash near the drivers side


simply cut the top vacuum hose going to the dump valve
.....
then add T-peice
.....
there will be a little rubber grommet(circled)that pulls away-
.....
pull it away and feed vacuum tube down and join the vacuum hose to the T-piece
.....
it will come out near teh back of teh ddash and is fidly
......
when you fin it....direct it to where you want to put your 52mm-60mm gauge
......
when you have your boost gauge location its time to get the tube to it
.......
when fitted and attached tightly the gauge should have a vaccum under 0 bar it only goes to the psi-bar side when under boost so no worries lol
.......
DSC00566boost.jpg


DSC00565.jpg


DSC00564.jpg


DSC00567.jpg


its a easy quick job as is needed for modified cars as the OEM one is poo:D

cheers.cal
 
Last edited by a moderator:
Top