Djaniero
Member +
Hi lads,
I'm trying to remove my lower ball joints at the moment on my GT, but can't for the life of me remove the 19mm castle nut (soak in a load of wd40). The gap is too small to get the ring end of my rachet spanner over it, so I attacked it with the open end side, but it started to round off slightly. Bar attacking it with a grinder, or heating it up is there anything else I can do to remove it?
Thanks
I'm trying to remove my lower ball joints at the moment on my GT, but can't for the life of me remove the 19mm castle nut (soak in a load of wd40). The gap is too small to get the ring end of my rachet spanner over it, so I attacked it with the open end side, but it started to round off slightly. Bar attacking it with a grinder, or heating it up is there anything else I can do to remove it?
Thanks