Tbh, they probably ask that even if there was no auto option, it's just a stock question.Copy that,
When I'm searching online it doesn't specify auto or man but when I call a local parts place they asked me. They are the same??
Ok. I've had another look under the car at the issue and I could be wrong but it looks like the grease is coming out from between the housing and boot. Could this just be a worn/loose seal and I could potentially replace that?
1st picture of the dodgy exhaust install when there is only a few mm clearance from driveshaft, 2nd is re-routed exhaust.
Could the heat from exhaust have loosened or worn the metal seal?
i used normal pliers to pull and apply that extra bit of force at the endHow do you pull the cable Tie tighter. It's not a regular cable tie obviously but is there a way to do it with your standard tools?
How do you pull the cable Tie tighter. It's not a regular cable tie obviously but is there a way to do it with your standard tools?
It's pretty close to the centre of the rotating assembly, but you may get some slight vibration by using those if you aren't careful.You can also use some decent worm-gear clamps snipped to just the right size if you are brave enough..