Recent content by asad_EP5DR

your inbox is full bud ^ my username on uksc is: Asad, been a member for 3-4 years....i only go home once a week so no landline let me know if i can help

you have ae86 panhard rod fitted, they have a kink on one end to clear the diff housing/reaching the filler plug easier/clear the exhaust too iirc

Correct ^ thats what it was lol no one spotted it its being taken to one of the best when i have time after fitting a panhard rod and sorted the wheel bearing out thanks guys

Hey all its getting to be abit of a joke now, i have meisters/whiteline antiflift kit and poly drop links and front bushes, its been at two different garages now (kwik fit and a john bean equipped garage) they both cant seem to give me the alignment settings i want -1 camber 0 toe and max...

Last i read samsung was doing quiet well..... http://news.sky.com/home/business/article/16098135 i have a 3GS and have done for the last 2 years? ive only just upgraded the frimware from 3.0 or WE to 5 its served me well tbh, htc/samsung/apple all have good phones (some even share certain...

earth for the ignitor pack ok? spark plug wells 100% clear of water?

when removing everything from the damaged head the buckets were mixed up (school boy error) the engineer was given all the bits and told to set the valve clearances on the 1st replacement head, this head was scrapped as it was later damaged and we got a 2nd replacement skimmed and transfered...

no luck guys, the valve is fine blows one way no cracks etc new symptoms: when cold the car starts and idles then when warm (cold idle turns off) the car refuses to idle and cuts out (dash lights stay on) the engineer says it may have something to do with the valve clearances/buckets...

Not sure if its the same on the starlet but, i did a water pump on a avensis and where you seem to have a leak there was a round rubber seal on the pipe this may be your problem

We had a poke about with it yesterday, but well test it today see if it makes any difference.... Thankyou, ill update as we go

when pressed, the cars idle stutters then just cuts out the dash lights stay on... yup servo pipe is ok no leaks and is intact, all the earths are fine (made sure theres no rust and sanded the area back) i appreciate it bud, thankyou

Hey Its a 1.0 02 plate french built No eml, slight miss fire but it drives fine...Dont have access to a diagnostic machine atm but it cant be any of the major sensors as they have been replaced What are you thinking? Thanks

Hey, firsty i apologize if this is in the wrong section bascially were at our tetheres end with this little car.....please bare with me on this one it started with a crossthreaded sparkplug hole (No3) we got an insert put in and all was hunky dory...till it concked out on the...

And the part numbers on the boxes?

Are these not the same as http://www.competitionclutch.co.uk/lotus-elise-18l-vvtli-6-spd-stage-2-2100-organic-carbon-kevlar-clutch-kit-p-25.html http://www.competitionclutch.co.uk/toyota-celica-18l-vvti-5-spd-stage-4-1620-6-pad-ceramic-sprung-clutch-kit-p-138.html...