Recent content by GlanzaGeek

Appreciate the help guys!

Tried it today and was the same. Checked the spark plugs again, and this time with someone to crank it saw only one was sparking. Swapped the plugs out and it cranked up straight away!

I will give this a go tomorrow

Yeah did have a code 22 coming up for water temp. But wiring ok, getting 4.8v to the sensor

It Is but, I removed the in tank pump and it should be getting fuel, as it looks like enough fuel in there

Hi all, Ive been working on my glanza project for a bit now, its on my drive and was running. The other day I was trying to get it on a pair of ramps and it cut out. I thought it ran out of fuel so I went to get some to put in, and just cranked. I thought because its on a slope maybe the pump...

Hi do you still have these? Also are they uncut?

So I've built a 4efte td04. Got an engine and dash loom for it wired it all up to a point where it starts and I've timed up with an ignition timing light. All good. Had an issue with my headlights being on constant, traced to bad connections in indicator stalk. Today, I had it running, ran out...

This is the two pin connector I have nowhere for

It's possible that the connector was taken off. I will send you a pic of the 2 pin connector now ...

I have the oxygen sensor blanked out on the decat. But also have a two pin connector around that area not plugged in, I thought that one was the oxygen sensor plug?

Yeah I've had the battery off and on again. The alternator is squealing like f**k could that set the knock sensor off?

I checked continuity back to the cluster and the oil pressure wire I have already connected is the right one. But checked continuity on this random wire and it doesnt go to the clust nor the ecu

Hi all, been racking my brain about code 52 knock sensor fault. It's the only fault showing on flash codes. Checked continuity from sensor plug to ECU connector and I'm getting continuity. So I unplugged the sensor and shorted to earth thinking it may think it's ok but still shows a fault...

So I don't seem to be getting boost on my build. Do I have my boost pipes right?