Recent content by gra893

Thanks chinesemafia...

ill try to search for the specs.. but a friend of mine selling me his 4e block with vitara piston on it.. the reason why his selling it to me upgrade to 5e block.. tnx just curious about his setup and how he made it fit... :)

Not sure but all i know is it's bore size would be 75mm.. usuaaly this is the choice of some honda d-series engine for boosting and also low cost..

Has anyone tried to fit a vitara pistons on our 4efte block? What are the pros and cons of this? tnx

around 1 to 1.1 bar w pump gas 96 octane and maybe later on will add alcohol injection on my system.. what would be the outcome some how? thanks for your rep...

thanks for the rep guys... here are the specs of my T3 60 trim .48 A/R exhaust side... http://www.treadstoneperformance.com/product.phtml?p=924&cat_key=290&prodname=garrett+T-Series+T3+60+Trim++ is it too big? ill be the one will map it maybe around 11.5 to 12 A/F @ wot? BTW the car will be...

Good evening guys, i have some questions... I just bought a garrett T3 turbo... 1. Is this good for our 4e engine? 2. How much hp could i make with it on stock internals with supporting mods? 3. As i want to build a turbo manifold for t3, what type would be great? short runners, equal length...

Gurus help! I just bought a 2nd hand EMU w/o the software... Where could i probably download or buy the software? What else do i need to buy for my emu so i could finally fit it on my ep82? i just want to run 1bar of boost... What settings do i need to do on the throttle settings? so i can run...

thanks mate...

bump... can anyone help me about this unit?

hi everyone....

safc 5 knob.. need help... could anyone tell me if this kind of safc any good for my ep82? @ 10 psi! if it is could anyone show me the wiring diagram & settings? thanks....