Recent content by RobPB

My spec is as follows: S/S Manifold S/S Decat S/S Exhaust system HKS Actuator HKS Fuel cut defencer Tuning developments 255lph fuel pump HKS panel filter FSE Rising rate fuel pressure regulator Gizzmo MS-IBC boost controller 160.057BHP @ 0.65bar and the AFR's are spot on. No need...

Queen Katherine Road, I think I saw your GT over by Meadow road the other week. Looks nice.

I'm the white Glanza in Lymington. I work in New Milton. Might have been me in Beaulieu as my parents live in East Boldre and it's a nice drive. Hi!

I am struggling to find a suitable place to put my FSE reg on my Glanza. Does anyone have any advice or pics? Thanks Rob

Are you sure it's not the autobahn88 one? They supply them. The actual Jperformance ones supposedly come with warranty.

Cheers, I suppose he's based in Ireland though right?

I'm thinking of buying a stainless manifold and decat from Jperformance as they do a deal on both for £275. Does anyone know if they are any good? Also, how much better in terms of flow are aftermarket manifolds than ported OE ones? I'm sure there was a guy on here selling them but I can't find...

Hi all. My suspension is getting sorted so I'm going to look at upping the power soon. Due to other commitments I can't justify eManage or a Hybrid ct9 just yet, so I'm after about 160bhp. I just need to know if what I intend to buy will be sufficient. I'm going to get an exhaust system...

Going to look at coilovers when it's practical to spend £600+. In the meantime, I'm looking for a good set of springs. Looking at RSR, Tein or maybe Whiteline. Does anyone have any experience of these?/Know any better makes? Also, can anyone accurately tell me what they lower the car by? I'm...

Transforms the car! Just make sure the nyloc nuts are all the correct thread! Mine weren't. Other than that it was a piece of piss to fit if you follow the guide.

Took the Glanza to my local garage today to see if they could fit the lower arm bar. No luck! Even with the heatshields removed it still won't go on. Going to return it tomorrow. I also got them to replace some nuts on my rear anti-roll bar because the ones whiteline supplied were actually the...

So I was being a bit of a dipshit really! I'll give that a go. Thanks for the help.

I thought it would clear it too. The mounting points are part of the chassis and can't move, so there must be something wrong with the exhaust right? Should I take the heat-shield things off?

Thanks guys, probably should have said I'm running the OE system! Can't understand it.

Over the weekend I fitted a Whiteline anti-lift kit and while I was there, I tried to fit a Whiteline lower arm bar. I bolted up one side, but when I tried to bolt the other the bolt holes wouldn't line up because the downpipe is in the way! The bar just hits against it. Can anyone help...