Recent content by Ruddock984

Hi all, was going to change the starlet to rolla mani in the sportif but noticed there as a ground stud on the back of the starlet mani but noticed there was no place for it on the rolla one. Any help would be much appreciated Matthew Ruddock

Hi all, I was changing the intake mani on the starlet to the corolla mani, but ran out of time to do it and had to keep the standard mani on. I have noticed a burning smell coming from this area. Any help would be much appreciated.

I have compared the two wiring diagram for both the starlet and the paseo and pin 10 on the A module of the paseo which is the tacho pulse. Looking to know if there is a wire for this or do I need to wire ecu. (Wouldn't know where to start if wire from ECU. Have read that pin A6 is swapped with...

did the soleil not come with a rev counter as standard?

Is the a wire behind the clock as I have read that when putiing sr clocks in a sportif, it is just a case of swapping wires over. I had had to wire from the ECU, what pins would I have to use and where is it located in a ep91 N/a

Hi all, looking to put white paseo clocks in my starlet sportif with no tacho. I have compare the wiring diagram for both cars and have identified which pins need to be swapped over but my main question is the paseo clocks have a pin known as tacho pulse from ECU. Is the a wire which goes...

Hi all, Looking to do the standard N/A starlet mods so putting on the Corolla tubular manifold and wondering can anyone point me in the direction of the gasket needed to be used. Any help would be much appreciated

Decided to go to canavans in lurgan. They done a good job. Got a cat back with 3.5" back box. Sounds sweet.

Before I decide to get a custom one done. Would the Japspeed cat back exhaust work on an N/A starlet. Probably wouldn't fit the existing manifold. if I go custom what should the inlet and the outlet be of the back box?

Hi all, looking to get a Custom Back Box made for the N/A Starlet. Does anyone know where the best place in Northern Ireland to get this done? I have mixed read reviews on Power Flow. Any help would be much appreciated.

Hi all, I'm looking for coilovers for a starlet. what makes are good. Need to be good enough for road use. Any recommendations?

It was the slave cylinder, it was leaking and there was no clutch oil hence why the clutch wasn't working so will have to get a new one. I just topped it up with fluid and bleed the system.

hi all, My N/A ep91 starlet is experiencing some issues. When putting the car into gear, there is a grinding noise. it happens in 1st, 2nd ,3rd. 4th and 5th are ok. when putting it into reverse there is also a grinding noise. I feels as if the clutch is not releasing. also the gears don't...

Could a bearing in the alternator be away with it.

Hi all, My ep91 N/A starlet (4efe), there is a rattling noise coming from the engine. The noise isn't coming directly from the engine. Its coming from the alternator area. Any help on this issue would be much appreciated. Matthew Ruddock