Yet another question
Has anyone any photos or diagrams of all the hosing/vaccum piping around the intake manifold ?
Looking for a fmic layout also.
Thanks in advance
I'm back again with another question.. so the corolla loom has a wire to the ecu labelled cooling fan but this wire has no pin location in the Glanza ECU ... Anyone have any idea why or what way to go with it.
Thanks in advance
So I've been informed of bypassing the solenoids.
We are currently matching the loom up do the plugs need to be still wired up if by passing this solenoid
So ran into the cat clearance of the subframe in the corolla problem..
Question is if I run a glanza decat to avoid the subframe can I plumb the exhaust back further to the original corolla cat?
I'm back with yet another question..
So I'm now aware that the 4efe and 4efte lower brackets are different...
I have both so I've bolted on the 4efte bracket to my turbo engine but only to realise the corolla pump doesn't line up for tensioner adjustment etc..
Has anyone modified the brackets?
Hi , my friend is mating up the n/a corolla loom to the glanza one and he is wondering about the wiring going to the dash in relation to the boost solenoid , hi/lo maybe. Not too sure but has anyone any info on this?
Doing the turbo corolla conversion so basically need anything such as ignition coil, boost solenoids, map sensor, sensors... Did I mention sensors etc anything under the bonnet the corolla wouldn't have... Jay chime in please
Hi I'm looking to replace the 4 studs between the Mani and turbo..
M10x40mm
Can't seem to find them but can get the manifold ones.. anyone know if they are the same?
Swapping my 1.3 G6 box onto the 4efte engine as I've been informed it will hold up. I'm not looking for mad power or going to be dragging the arse out of it daily .
Would I be right in saying the glanza clutch should be used here to mate to the turbo flywheel?
The turbo mani is cracked...
I've located an engine.. still in the car as my glanza engine is not optional to be saved..
The engine is in a GT ..
I want to use my glanza loom and ECU..
Will this work swapping the sensors etc from the glanza over to GT as needed?
What ones will need swapping?
There's light at the end of the...
So I recently set about to do a 4efte swap on my G6 corolla and the mechanic hit me with some news of bad scoring on cylinder two he reckons it may not be able to be saved..
Hi ..
I'm currently doing a 4efte swap into my G6 corolla. The glanza engine I got is known to me. The last time this engine was running it was spitting oil out the dumpvalve and I remember the turbo and dumpvalve being changed and the problem continued.
Engine was removed after this.. anyone...
Hi lads, it's been years but I'm at it again with Toyota. Sold the GT then the Levin and back in a G6 corolla
I've gotten a glanza engine and ecu but wiring is the problem is there anyway around this other than a glanza loom? I can't locate one
hope this is right section...apologies if not
recently i bought a fmic blitz kit off this guy
http://cars.donedeal.ie/for-sale/carextras/2680793
he said his name is mikey...drives a 05 shape avensis
said he was from salthill...two numbers in the ad 1st 1 is his other is some...