Search results

  1. S

    plumbing oil catch can???

    hi, i have reccently fitted front mount intercooler and relocated air filter which meant i needed breather filter on rocker cover and i replaced pcv valve with new one ever since iv had blue smoke on tick over. im finkin excess oil is goin in inlet mani from pcv valve due to mods. wots the...
  2. S

    white oily smellin smoke on tik over

    hi guys, recently added sum mods to my glanza. the turbo was removed fitted fmic hks actuater ss mani ss decat new filter added breather filter on rocker cover as removed tmic piping before i added the mods i noticed a bit of white smoke on tik over but now it is pretty bad sat at...
  3. S

    advice needed

    im currently fitting fmic and relocating air filter, the black pipe coming off turbo to induction filter has a hose going into it jus under hot pipe on tmic the hose gos to side of engine. when i relocate the air filter what do i do with this hose?
  4. S

    boost guage idling at -0.6bar

    hi all i bought an electronic boost guage brand new off ebay, its a apexi EL system meter series. i plumbed the boost sensor supplied with the guage into the into the boost pressure sensor pipe located on the bulkhead this is the pipe with the inline filter (round rubber thing in middle of...
  5. S

    fitting electrical boost guage

    hi all im just fitting my boost guage, wiring sorted just trying to plumb the boost preesure sensor suplied wit guage into boost pipe. will it read boost if i plumb into pipe between inlet mani and bov?
  6. S

    fitting new fuel pump glanza ep91

    hi im currently modding my glanza to run 1bar on ct9 hybrid, iv just bought new walbro fuel pump to replace old worn out pump. any1 got any tips on how to fit? were its located?
  7. S

    is fse power boost valve good enough to raise fuel pressure to run 1bar boost ct9??

    hi guys im looking for a rrfpr good enough to raise fuel levels to run 1bar on ct9 turbo. iv seen fse power boost valve with adjustment guage for 100quid, thought itd do job plus could monitor pressure adjustments via guage. anyone recomend these or any other rrfpr? cheers
  8. S

    increasing boost on stock engine and stock ct9

    hi all, iv owned my glanza for a couple of years and its been standard apart from hks hi power silent exhaust and hks filter. i bypassed the boost solenoid a while back and have been running hi boost, but now im after a little more power, i now own: jperformance fmic 100mm thick core similar...
Top