Search results

How much power can stock 5efhe rods handle? I mean how many torque and RPM can handle I want increase the stock rev limit to 8,000 rpm and try to get 300 whp and 2xx (ft-lbs ) I have forged 4efte piston with a CR 9:5.1 and 5e fhe rods Is possible get this result?

some body know the diferences between his manifolds of admission ? trotel body ? CMF capacity ? wich one gain more whp ?

some body know the diferences between his manifolds of admission ? trotel body ? CMF capacity ? wich one gain more whp ?

i want build a engenie with this setup inyector 375 TD05H 16g glanza V stock fuel pump 5e-fhe manifold admission port and polish head with angle Job Asc Head Gasket 1mm 5e-fhe rods with 4e-fhe piston Apexi S-AFC2 custom exhaust manifold 2.5 down pipe and exhaust stock ecu my...

both with the same compres 9:5:1 i want run 1 bar of boost with this spec fuel pump turbo t25 manifold custom exhaut 2.5 inyector 580cc apexi s-afc2 port and polish head with angle job ported admission stock head bolts stock trotel body so , pleae give me your opinion

this is my question can i make 260 whp with this.. my setup: rods fat (starlet GT) Turbo T25 manifold custom 2.5 exhaust AEM Water/Methanol Kit port and polish head with angle job manifold of admission polish and ported injectors 480 cc (Evo 7 GTA) Apexi S-AFC 2 please give some tips..

please check this item , tell me you opinion about this: is posibble increase the WHP just with this ? http://www.ebay.com/itm/320990456786?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2649

hey dear friend i am from dominican republic , i have a ep91 with a few mods :D i change my rods for other a little stroger check this , the left rods is my actually rods that work in my engenie now , i want know how much WHP can withstand? , sorry for my bad inglish but my...