Search results

  1. N

    Will 38mm tial EWG spring work in 38mm turbosmart EWG

    Most likly a stupid questionas its two different companys but would the tail boost spring fit in a turbosmart WG
  2. N

    0.8 bar turbosmart extranal wastegate spring

    Does anyone have a 0.8 bar wastegate spring
  3. N

    Td04 kit on standard

    Can I put the Td04 on standard injectors, not change head gasket and no map or will this just create problems. I have all parts minus injectors and metal gasket.
  4. N

    Over boosting since fitting exhaust

    When i put my foot to the floor the car seems to jolt and sounds like its sneezing (couldnt think of any other way to describe it). The EML also comes on. I have been told its over boosting but ive turned my boost controller right the way down and it still hasnt made a difference. Any help would...
  5. N

    Oil light doesnt work

    When i switch the ignition on and all lights light up apart from the oil light. I have taken the clocks off to check the bulb but it hasnt blown. I think i remember seeing somewhere that when a KMH/MPH conversion is done it can mess things up a bit. Is this the problem or is it something else ?
  6. N

    Fuel light just stays on even with full tank of fuel

    Okay so i was a bit stupid one day and ran my fuel down till the light was constantly on not where it comes on and off as the fuel swishes around in the tank but since then the light remains constantly on even when i have just put a full tank of fuel in. I havnt done an engine diagnostic would...
  7. N

    Toms 15" alloys Value ???

    Can anyone tell me what a set of these would be worth looking at getting new alloys depending what these will fetch. Was told by previous owner these are very rare. Can anyone give me a rough estimate on what they are worth and if they would be interested in purchasing.
  8. N

    KIWI PLX OBD2 port ?

    Does the glanza have OBD2 port ? for KIWI PLX Im looking at getting one of these as i quite like the idea of a tablet full of gauges than pillars and dashboard covered and it just looks more tidy and neat. But my question is does the glanza have an obd2 port ? and where is it located ? or will...
  9. N

    TD04 Help

    Recently purchased a TD04 turbo recieved in the post today and just want to check i havnt been stiched up. I was checking over the turbo and noticed it doesnt have td04 stamped anywhere on it all it has is n2 ? is this still a td04. Also has a toyosport mani should i be looking to replace this ...
  10. N

    What do i need for TD04L upgrade ?

    Hello, recently purchased as TD04L turbo kit and civic short rad and fan. Im going to be removing the A/C and relocation air filter behind front bumper. Just wondering do I need anything else instantly when fitting or can I add as i go along.
  11. N

    Civic short rad brackets

    Does anybody have a set of brackets to fit the civic short rad for ep91 as dont have the tools to hand to make some. Thanks in advance
  12. N

    how to fit short belt after A/C removal

    Going to remove my A/C (gases will be removed by professional not me) in order to fit TD04, civic rad, relocate filter ect.ect. Foun a guide on how to remove but doesnt say anything about fitting the short belt, where does it go and how do you fit it and what tools will i need. I really should...
  13. N

    Oil in end can :S

    Oil in back box :S Just seen today when going to put my exhaust baffle back in that the back box is covered in dry oil. Any input on why this would be happening ? and would it cause the car to over boost ? as my manual boost controller is turned down as low as possible but car always over...
  14. N

    Wanted!! Japspeed 4 1/2" exhaust baffle

    Does anybody have a japspeed exhaust baffle they dont want or have laying around and can post. Mine seems to have dissapeared :S
  15. N

    How to fit/install boost gauge ????

    Hello. Need to fit a boost gauge to find out what boost my car is running at to try and solve an ongoing issue with the car before i start buying unnecesary parts and for future mods. Anyway was wondering if anyone could give me an in depth guide on how to fit a boost gauge and which would be...
  16. N

    HKS FCD to use or no to use ?

    Hello. Im new to this site totally new to the whole turbo car and have no mechanical experiance at all. Ive recently found out that my glanza may have a Fuel cut on it but been told by jefferys (plymouth) that they dont. After fitting exhaust I was out that night and driving at low speed with...
Top