Search results

Hi all I'm looking for some help . I'm planing on doing a Mod on my car "Totota Tazz" AE92 Hach - it's a 2wd and i wana make it a AWD , I was wondering if anyone has some pictures of a AWD GT rear stub Axels and Hub .

What is this and What dose it do ???

Ide like to know there are 4 wires thar conect to the Distributor 1. Blue \ Green line 2. Pink \ Blue line 3. White \ Blue line 4. Blue \ White line What are they , I need to wire my it to my ECU ." Non STD " Im using a Gotech MFI .. >

Hi Im looking for 3ETE pistons ... STD - Full set with rings .. Are they avalable , and at what price ... Thanks

Just a Quik one ... is the 4EFTE and a 4AFE head gasket the same .>

Well its time to Rebuild the 3ETE ....

Just a quik 1 How much oil should or could an engin use on a full tank of fuel . Im using about 250ml to a tank, And getting about 380km to a tank 55L. Is this normal or am i starting to use more than i shoud. Im running 1 bar boost and love the sound of the dumb so ... my foot is...

I was doing 137 Mhp ..... I drive stright in to a wall and not a scrach..... NFS is a GR8 game dont get hurt or damage the ride :p

Im holding a 1L bottle of Castrol 5W30 SLX ... There are no spare shops that keep stock of it . " SO WHERE DID I GET IT FROM ? " BMW keep it is stock for there cars ......the SA BMW stock coad is " BMW LLO1 " I hope to those of you that find this intresting can find 5W 30 at your...

1st Gen 4E-FE The first generation of 4E engines found in the Starlet GI and Solail models were produced from 1989 until 1996 the engine found in these two models obtained power figures of 99 bhp @ 6600 rpm and 86 ft·lbf @ 5200 rpm. this engine had more in common with the 4efte sharing the same...

Hi all With the change of engen from the 2E to the 3ETE .... Im using the same GB " 5 speed " Is the GB the same from the 4E and the 4ETE ... ? And can one take the GB from a 4AGE and change the bell housing to fitt the E series Engins...? Im looking for More top end ...

Just a Quik one .... What should the Oil Pressure be Hot and Cold ... Mine is 4.2 Bar ..420 Kpa +/-

....... Looking to up upgrade ... Go as fast as a silent fart...> http://www.davescybernetics.co.za/23112007.jpg .......LOL

some info on the E-Series Engens http://www.davescybernetics.co.za/trd-tazz/E-Series-Specs.jpg David

Hi there here are some pictures of [IMG] http://www.davescybernetics.co.za/trd-tazz.html Let know if there is more you would like to see .

Im looking for a CT-12 as new as posable . The sharft broke inside mine .

Would any body know where the Marks are for the cam timming on a 12 VALVE Head and 5E Block. Ive got a 3ETE Wich is a 1500cc 12 Valve . and not a 5E or the 4E 16 Valve . I Bought the motor and redone the darn thing but never checked the cam timming when i striped it. I done the same...