Search results

Hi guys. I am trying to figure out why my 4efte Glanza V Hi Low Boost solenoid isn’t working. The solenoid works, but the ECU isn’t putting the VSV1 signal to ground to engage the solenoid. I am actually looking for the full manual in English because I have only a Russian version… if you check...

Hey guys. I can’t figure oit where the rear intake manifold vacuum pipes should go. In the Corolla 4efe they go to the steering pump. Where do they go in the Starlet? This system pull up the idle rpm when moving the steering wheel. Let me know what you think. Corolla Starlet

Hey guys. i want to forge my 4efte engine, but I was thinking to do the work on another engine block. This way I could keep using the car while the job is done and then put the fte head on with upgraded valve springs. I would also swap the oil sump that is different. Oil pump ahould be the same...

Hi guys. I bought a C52 gearbox pulled out from a Starlet GT ep82 and I put ot on a ep91 Glanza V engine in my Corolla Ee111L (European version). When I put the Corolla 4efe drive shafts in I found out that the tripods were cracking which means that they are too long in this gearbox. When I...

I bought it but I don’t need it. Never opened the box. Let me know if you are interested. If you don’t know what it exactly does, it has to be connected to the speed signal on the loom close to the ECU to get rid pf JDM speed limiter.

I am looking for a distributor housing because mine stopped working. One of the magnets is broken. It happened while I was getting the arm pin out to get to the oil gasket. Anyone can help? @Jay @RoyalDutchie

Hey guys! i opened the distributor to stop the oil leak and discovered the teflon seal inside. It needs to be replaced but there is no information about it and no OEM on the parts website. Why? I changed both gaskets but obviously the oil gets through the dented arm all the way in the rotor...

Hello guys! if you weeks ago I read about the procedure of putting the diagnostic pins Teat1 and eat one together in order to cut the ECU compensation on the timing. This procedure is necessary to set the mechanic timing on +10. Removing the diagnostic mode will allow the computer to set the...

I’m selling a pair of genuine Starlet Glanza/GT fog lights. They’re in great conditions!

Hi guys. I came to the point that I want to install a front mount intercooler. The question is always the same. Will turbo lag change? How much? Everyone told me that the 4efte engine suffers when keeping the original intercooler. I thought that Toyota knew what they were doing, considering the...

hi! Today I went to see the tuner and he told me about the ECU classic. He explained that it would be perfect because the engine has a wire for the Excelerator. He asked me to find the original Toyota 4efte ECU female connectors in order to make the ECU swap easier. Is there any company that...

Apparently apparently am in the situation where are the engine is burning some oil. Some people say it might be the turbo and some people say it might be the valve gaskets. Someone else says it might be the lower piston rings being sticky and letting some oil get in. The plug sparks are looking...

Hi guys. i swapped the engine and there are issues to fix. Communication between dasboard and ECU/sensors like RPS signal, alternator doesn’charge, engine check light on. The car doesn’t start at first ignition. It need several cycles before it starts running. The problem happens only when you...

Hi guys. I am missing some pipe on the engine because I swapped in a Corolla E11. I need some help to figure them out.

I finally pulled up the 4efte engine to prepare for the swap on a Corolla E11. I have some important questions for you guys who have already worked on swaps. I need to know where these connectors go what they are for Do you have a diagram with the connector names and code? The Corolla has more...

Hi. I am about to buy a 4efte engine to swap it with a 4efe in a Corolla E11. I was told I can use a 4afe gearbox as it has same resistance to torque as the 4efte box has. Is it true? If so it would save my money. It will cost me £350 compared to the £700 for a 4efte gearbox. I also need a list...