Search results

Hi All, My 92 EP82 came with the Reacro interior. The front seats have seen better days. They have adjustable thigh support and the headrest are solid not netted. Does any one know if these seats are similar to the Recaro LX or LS seats. Also, would the parts on this site...

I am getting an ECU diag code 12 and the engine brakes up on high rpm under load. It gets worse as the day gets hotter. The last time something similar happened it was the distributor. Something about grounding in the distributor. I had an extra one so I just swapped it out. The only one I...

I ran into the back of another vehicle and I need an A/C condenser for a early 92 EP82. Its the condenser which has the R12 gas fittings not the 134.

I want to change the door hinges on my ep82. Must I remove the fender or can it be done without removing it. Also, if the fender has to be removed, is it a simple process? Thanks

HI, Does anyone know what the bit at the bottom of the throttle body attached with the 4 screws do. I have been having so idle RPM problems for sometime now and I have narrowed it down to the throttle body. Was wondering if it had to do with temp and idle speed. Regards

Ok, I am getting high RPM on idle. The car idles between 1900 - 2100 RPM. Sometimes it my drop to about 1100 for a while then goes back to about 2000 (no set pattern). Was driving very aggressively up some very hilly and winding roads and when I got to my destination i noticed the problem...

Does anyone know the A/R of the CT9, mainly the turbine size. I wish I could do a search on the site but I cant use words like ct9 and a/r. Is this ever going to be changed??

Hi all, my turbo bearings are shagged. I can get a CT26 rebuild from a friend but I need to know if the bearings will fit the CT9 turbo. Thanks

Can someone tell me where the compressor clutch relay for the A/C unit is located in the EP82.

Can someone tell me where the compressor clutch relay for the A/C unit is located in the EP82.

Has anyone installed their WEPR ct9 power up kit. If so, I am interested in knowing what difference the kit makes other than preventing boost creep.

Hi Folks, Can anyone tell me what is causing my A/C light to flash. I turn on the A/C, the compressor comes on for about 5 seconds (does not cool the car) then shuts off and the light begins to flash. You help would be appericated.

I just bought and FMIC. The core size is 17.5"X11.75"X3" the overall size end to end is 25"X11.75"X3. Currently I am running one of JD's CT9 kit 1 turbos. Is this FMIC too big??? I don't want to get a lot of lag. Any advise would be appricated.

I just installed my TurboXS Dual stage manual high performance boost controller and was adjusting hi and lo boost settings. After a couple of runs I find that when I get to about 13 to 14 psi I get a rapid popping sound out the exhaust, the car hesitates and the a/f gauge goes from 10.6 to...

I ma trying to purchase one of these. But since I am in the Caribbean I am trying to get it out of the US. I know that in the UK the part number is QDF15E but I don't see this number on the US site. Could it be the same as 94.309.155 on the US site because its for the Corolla AE92 and non...

Was thinking of purchasing an FMIC. The overall dimensions I was looking at is 28x7x2.5 (Bar & Plate type). Would this fit on an 92 EP82 with A/C and without making adjustments to front bumper. Also would it work efficient (ie. very little lag) with one of JD's Kit 1 turbos boosting at 18psi.

Hi all I am in the process of hooking up my TurboXS dual stage high performance boost controller. However, I don't want to run another wire trough my firewall (way too much already). I was thinking of using the existing turbo switch and somehow connecting the TurboXS wires to the connector...

I just change my engine. My last engine idles at around 700 - 800 RPM and I could make adjustments up or down with the idle screw. This new engine idles at around 1100RPM. When I adjust the idle screw the lowest it will go is to about 900RPM. However, if I go into diag mode on the ECU the...