Search results

these error code are getting on my nerves could somebody tell me how to solve them thank you :confused:

yeah i should think so

sometime my car gives problem to start it sounding like its turning over but it will not start unless i mash the gas could somebody tell me why?then today while reversing it cut off and came back on withing seconds but when i look at the wideband its all the way on 10??????

my car is smoking now onidle i and it not even 3weeks sincie i change the vale steam seal cause it was smoking i think i will try the pcv valve

i was looking down by the turbo and i see one of the hose is comming loose i think that could be the problem am going to change the clamps and see.

could somebody help me with theses two codes i know what they mean but i need help solving them. am running bigger turbo,emu and using a apexi avcr.

think i will try the piston rings first thank guys

i had a problem with blue smoke from the exhaust when am slowing down or going down a hill,so i change the valve steam seals and am having the same problem:confused:could someone tell me what could be causing that problem. thanks much

i had error code31 and when i change the map sensor i went and i did not had to remove my emu now am error code 14

what causes slush in the valve pan

i could not get the 4efte seal so i took to the 4efe seals is that going to be a problem

how hard it is to change them???

am using a garrett t25

sorry i mean advantace when tunnimg he tune it on 15psi an advantace the ignition 10degrees so i wanted know how much more cant you advantace the ignition?http://www.youtube.com/watch?v=ulRSY-7PLEo

quick question how much degree can you retard the timing when tuning? with stock internals

i have notice when i running and i slow down i see blue smoke from my exhaust and sometimes when i change gear, what could be the cause of that?:drive:

i have the silver and am sill cant work it properly when its off i could here my wastegate opening when its on gauge reading set boost and controller readuing something different???? dam thing too technical

when the controller is off the gauge is showing 6psi and the avcr display screen is showing .39 the boost gauge is a prosport

external wastegate

it is set a 1bar and the duty is at 61%