Search results

  1. E

    Injector physic dimensions

    Does anyone know the physical dimensions on 4e/5e engines? Length, diameter++
  2. E

    After marked camshafts. Are they worth the money?

    As topic: Is after marked camshafts worth the money? Got a forged 5E-FE engine with ported and polished head and will use a GT30 turbo.
  3. E

    Will a Tial 38mm be enough on a GT30?

    Already have a Tial 38mm ex.wg on my current setup. But will upgrade to a garrett gt30 turbo. In that case I'll wonder if the wg will hold. Or do I need to upgrade to a 50mm? Will run 1,5 to 2bar boost.
  4. E

    What turbo on 5E

    Doing some serious upgrades this winter on my Starlet so the question is; what turbo to go for. Aiming round 400whp Engine specs: 5e-fte forged rods and pistons 1000cc/850cc injectores Ported and polished head Uprated valvesprings ++++
  5. E

    Specs on 5e-fe cams?

    Does anyone know the specs of the original 5e-fe cams?
  6. E

    Where to by 1000cc injectors?

    Anybody that knows where I can buy some 1000cc injectores for the 5e engine?
  7. E

    What is this hole side of block

    What is this hole for on the timing belt side of the block? Right over the oil pump. What should be there?
  8. E

    Rear suspension arm bushes?

    Does anyone know the size on REAR SUSPENSION ARM bushes? Would liked them in poly. Need the size so I can order it.
  9. E

    Bearings

    Hi I'm rebuilding my engine with Ross pistons and Scat forged rods. My question is; how do I messure what bearings I should get?
  10. E

    Weight of oem flywheel?

    Does anyone know how mutch the oem flywheel weigh?
  11. E

    440 topfeed injectors from 2jz

    Does anyone know if I can use injectors from the j-spec 2jz? 440 topfeeds? Are they a direct fit? Edit: They were not from a 2jz. They were some Delphi 440 high ohm topfeeds with Bosch fittings
Top