Search results

Your insured then, i went into halfords for a bulb gave them my reg and it came up with a corolla lol so don't worry about it

There is no problem with that just seems pointless to have it on a standard car, isit running standard boost? if it is then you dont need a fcd but spose aint any harm leaving it on there

post the way to do the test up as he coming up mine now

from empty im sure it 3 and half litres

Just thought ill give you all a heads up. Before i start ill admit i was a mug to do this but here we go, he bought a couple of bits off me and paid up ok now he rang me about 4months ago now and asked me a favour of letting him have my wheels and he give me the money a week later he was good...

It says at top mate rear wheel bearing and seal. I think dave selling the wheel bearing!

Ive always preffered GT because they look more mean but i like the look of you Glanza (Propa mean looking)

Welcome your learn alot being on here mate...

I Should Think around 150-160

Pm a price for the whole car just needing the engine

You done your bearings in!!!

I would say 100% headgasket do a sniff test mate!! Il try find you a guide for it

My area had risen nearly 20% looking forward to renewal lol

Im F* Typical being in croydon!!!

Someone's rattled your cage lol.... carm down its a advert:p

Lol, If compression is low in one or more cylinders, you can isolate the problem to the valves or rings by squirting a little 30 weight motor oil into the cylinder through the spark plug hole and repeating the compression test. The oil temporarily seals the rings. If the readings are higher...

Im sure the N/a And glanza have different amount of splines on the driveshaft but don't know if this will affect ill leave it to some1 more mechanical lol

But like everyone has said oil in first mate! As a rule, most engines should have 140 to 160 lbs. of cranking compression with no more than 10% difference between any of the cylinders. Low compression in one cylinder usually indicates a bad exhaust valve. Low compression in two adjacent...

Sorry mate what i mean is surley if piston rings went the compression wouldnt drop that much?

mmmmm Thats a werid one i would have thought piston rings going would cause the compression to drop that much?