Search results

  1. G

    Wanted !!!

    I am looking for a ct12 c turbo in good condition. Thanks........
  2. G

    glanza v fmic and external mani...

    for glanza v hdi fmic (only ep91 not ep82) or piping kit only and outlet mani with external for ct9 setup. please pm me , thanks....
  3. G

    problem with idle rpm ...

    hello ... i have this problem for a few days now , when the engine is warm it has around 1200 rpm ! i have check almost everything and i can not find the problem. there is no loss of pressure from tubes , i put a new pcv valve , egr valve is good , tps and throtle body is like new and clean...
  4. G

    Cooling fun switch valve?

    Hi everyone i am about to change thermostat from 82 degrees to 76.5 (from paseo) and also i must change the cooling fun switch to suite with the thermostat temrature but i can't find which one is the for the cooling fun (1 for the temp gauge , 2 cooling fun , 3 for efi "warm up") all of these...
  5. G

    question about manifold

    hello there you will help very much if you tell me what should i choose... about 1 year ago i bought a Jperformance s/s mani and from the first month i had problems with the flange mounted to the block so i take it off get it flatened and put it up again but in a few days i had the same...
  6. G

    hdi fmic for glanza v

    i'm looking to buy new or used (in good condition) hdi fmic for ep-91 glanza v and only (not the fmic that suites also to ep-82) ... if anyone can help i'd like to know total price with shipping cost to greece-creta... thanks tim...
  7. G

    problem with A/F ratio

    hey it's about 10 days that i have start using the car and i have seen that the a/f gauge shows lean over the 2/3 off the throtle ... do you know what i have to do??? you think that matters that it was auto and i made it manual (i put a 30ah fuse in the auto gear lever unit at neutral position...
  8. G

    help ...

    i converted my ep-91 starlet to glanza ... i bought a half car glanza atm rhd from japan and put it on my car with all the wiring harness but i have a problem , i don't have power to the starter and to the fuel pump! the ecu code is 89661-10210 4efte atm (black label & 3 plug) is there any...
  9. G

    hey everybody

    hello from greece-creta i am an owner of a starlet ep-91 and i'm making it glanza because i am in love with this car and i just want to make it better!!! by the way i'm gonna need all the help i can get.... thank you for accepting me to your club :)
Top