Search results

Cool, appreciate all the info lads rep added

will this have any effect on the air fuel ratio? say if i set it to .75?

not really after more ponies just seeing if i could up the boost slightly without the need for supporting mods like piggback ecu or fcd an fpr.. Have an apexi cat back sys to go on & rx7 top mount ic, manifold is standard but will be porting that. Just dont want to up the boost past standard...

Im getting a hks actuator & im wondering if i can up the boost to a certain point without the need to get FPR etc?? Standard EP91

Fair play for sticking at it man.. alot of people would of taken the easy option an break it. Looking forward to seeing this finished.

Bump

bump

Looking for both driver & passnger rails..

Picked up a set of deflectors the wknd so Just looking for the actuator now ( pin type )

ttt

Bump..

bump

They that bad? Lookin to get 1 soon enough if any1 can advise of a good manifold to get. Dont wanna spend crazy money.

Anyone using this? Are they decent? Would be put on practically standard EP91 http://www.ebay.ie/itm/Toyota-Starlet-EP82-EP91-Turbo-Exhaust-Manifold-/190480542504?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item2c59866b28

Lookin for a HKS actuator + toyota wind deflectors for an EP91 Pin type afaik

CT9 standard setup

What is the diameter of the hole on the vacuum hoses connecting the actuator to the turbo & solenoid? 6mm 8mm 10mm? Im also installing a new boost gauge is it the same diameter for them lines too?

Sorry to hear this mate, my car was tried as well bent the door back still isnt right. Hope cctv helps catch them. Expensive to repair/replace?

no one even goes near the two people hit... China springs to mind

pm'd