Search results

as above so engine can be removed?? cheers

going to fit my new box soon! ive read the guide on her so should be ok hopefully. not looking foward to getting the shafts out. But when putting the shafts in. do i just put the circlip on the end of the shaft and push it back in? How do i know when its clicked back in? For removal...

as above for ep91 aftermarket ecu mines,blitz,jam, whatever is available please? cash waiting Please private message me for a faster response. Thanks

ive got all the mods to get my boost slightly turned up Just need to fit the fcd & actuator & fpr now. Im planning to run 9 psi or a 1 bar MAX I havent ported my turbo, but i dont have that much creep at the minute. Should i set the actuator at 9 psi to be safe and expect a creep of...

Ive got space for 3 gauges currently got one boost gauge So im after two other gauges? Are the Air fuel ratio ones good or bad? Wanted something fairly cheap eg no sandwich plate cheers

hello ive got a leak from what looks like to be from the oil feed(from sump) to turbo Its come from the gasket to turbo area. as its seeping and coming from one of the (two)bolts that is pointing down. Should i get a new seal? or can i use some sealant around the edge and tighten it up...

got two questions so thought i would put it in one thread. abs light on 33) Problem in right rear wheel speed sensor circuit. this is the code im recieving on my glanza! would this be classed as the sensor itself? Im not running a speedo and havent drove it as its off the road, only...

As above really? How you remove it safely? Just the boot lock! As I'm swapping boots. There's no transponders on it or anything? Cheers

as above been in touch with some shops they seem to be all out of stock:( what you got:) thanks

as above electronic what you got:)

its the mucky white one what is this? what it for? what does it originally go to? thanks

as above i think there the same offset as starlets 4x100 will this fit a ep91? thanks

as above wheels with tryes no more than 350 what you got? 15/16s ideally spokey like team dynamic pro race1.2s or some sort of colour lip panhard rod asjustable thanks

hello found this for removal of rear windows http://www.toyotagtturbo.com/forums/showthread.php?t=46691&highlight=side+windows is this the same for the ep91? thanks

hello im more confused what to do than a illegal immigrant atm i have fmic but i have the number plate in the stock location so to be honest you carnt really see the fmic unless you stare. my question or opinion do i cut out the shitty middle bit get abit of touch paint and go...

rear boot ep91 silver ideally open to what uve got boost controller in car ideally electronic butwhat you got? thanks

never really noticed it. till yesterday one side of my rear is lower than the other the springs look ok(no cracks i dont think) not checked the shocks for leaking was only a quick anaylsis as it was sunnyy then just went black:( if its not the shocks and the springs what could it...

rear coilovers or springs wheels ep91 coilovers. springs to come with damper and strut wheels 15s/16 ideally spoked bt open to offers.

hello buying a new boot it has nothing on it but the boot and glass so i will need to put the middle panel on and the spoiler and the new lock out and my one in main question is it hard to take the spoilder off mine then put onto the new one? and take the lock out of mine and put it...

2 sets of wheels.. New Pics..New price For sale:wolfrace street octanes Item Condition:very good par from little kerb mark on front rim(under 1cm) Price and price conditions:SOLD Extra Info:tryes 3 radial n3000 lexani 1 federal with all brilliant tread Pictures: Contact...