Search results

For sale:4efte block Item Condition:good condition Price and price conditions:£40 Extra Info:the reason its up for sale is because i bought a engine for spares and its just sitting n the garage Pictures: Contact Details:post me Location:newcastle Delivery & Conditions of Delivery:i would...

im after a good starter motor and a turbo hot pipe for a fmic (glanza V) cheers

Hi just a little help please but does anyone know any good engine fluid additives that I can use to eliminate engine ticking noise???anything from halfrauds

Hi could I just have a little help on a boost question. I just recently fitted a new engine and took it out for a drive and it wasn't boosting past 0.5 bar. So I took all intercooler pipes off and couldn't find a leak,I took the vacuum pipe off the actuator and it wanted to boost past 1...

hello just some help please.im trying to prime my turbo but when im cranking it the oil light wont go off and there is no sign of oil coming through the feed pipe???? is there anyone whop can help maybe a connector or something as ive just fitted the engine cheers

Hi just some help please,im putting my camshafts back in and the both wont sit right they have a gap under where it sits .ive got the timing marks right. Do i just put the bearings on and just tighten it up or???

Ive just looked at the headbolt torque specs and just want to confirm that they are right 1st 22nm 2nd 44nm 3rd 90nm when i looked at it on here the 3rd one had 90o thanks for help

Anyone know wheres the best place i can find head bolts and a timing belt for a glanza v cheers

ive recently fitted a engine as my old 1 span a bearing and couldnt be arsed with the hassle. when i fitted the engine i first started it up and noticed a missfire on idle and took it out for a test run and has loss of power on boost and was smoking as if it was over fuelling,so i got my uncle...

Hi ive just fitted an engine to my car,would i need it setup on a rolling road again

Has anyone got a clear diagram of the 4efte engine layout just my engines been out a while now and all the parts are cleaned and going on a different one so just a diagram to refresh my memory please and thanks in advance karl

just blew me engine unfortunatly but wanting to keep the starlet so im after a cheap engine cheers

hi i just want to know a little bit about the quality of dave burwashes forged engines he does as i cant seem to find any info about them from other members cheers karl help much apprieciated

wanted a cheap engine???

cheap run around will pay round 5-600 quid cheers karl

has anyone got an uprated actuator lying about mine is dead cheers

Just a little help if ya can i dont know if its just the shitty toytuning actuator or what!! When my foot is down it does go to 1bar then drops to 0.7....ive got a hdi dual boost controller set to 1.0bar gt spec hybrid

Hi i can get an hks fcon quite cheap but i already have a safc2 tuned to my car would it be any point in buying it ??? Would it do exactly the same thing?? Cheers for help

Has anyone got any type of handling parts for a ep91 apart from coilovers cheers what ya got???

Anyone got an engine damper for a glanza cheers