Search results

Any one knows the duration @ 1mm specs . ? If some one has degreed them on installation what figures did you get? Thanks

anyone using this on the 4efte? looking for reviews

Hey All, I'm from Trinidad WI. I've finally hit the tracks with my 5e tercel , recently tuned on 92RON and methanol injection with an Apexi Power FC to 300 WHP , 22" MTs , TRD LSD , TRD MR2 suspention, stock axles . Got 7 passes : 12.5s 12.8s 12.4s 12.3s 12.3s 12.2s last past is the vid ...

I am getting the option to buy the stage 5 competition clutch or act extreme kit , both discs unsprung. Goal: I am looking to hold 350wtq . without going twin plate Need some help deciding ,Thoughts are welcome :)

will it grab 350 tq to the flywheels? :confused:

shifting from 1st to 2nd only grates at high rpm , so I'm not able to drag race the car , it shifts normally under normal driving ,new clutch ,pressure plate , flywheel and release bearing , the master and slave cylinder (hydraulics) are good , the gearbox was opened , syncros and gears very...

can running a waste spark setup encounter knock more than distributor or COP ignition systems? Your views please I'm thinking sparks on the 'waste' cylinder igniting a fuel/air charge especially with a cam with a lot of duration and positive intake pressure compared to exhaust pressure

anyone ever used this with an aftermarket ignition successfully ?

Waste Spark Ignition conversion i want to run a waste spark ignition using the stock coils of the dis 4e , i already have a pair , does anyone know the pinout for these coils?

i wanted to start a thread to compare gains (timing advance gained , HP , TQ) using water /meth injection. state your set up , boost , turbo, CR, fuel , water/meth ratio, water/meth injector size and gains. setup: im running built 5e ,haltech e6x, t3t4 60 trim turbo, 24psi ,9:1 cr, base...

does anywhere (website) sell a copper oringed 'upgraded' version .

this is the 4th clutch ive broken this year. after i broke the first (ACT 6pad no spring copper) i changed to a new fidanza heavy duty p plate , new flywheel , release bearing . and the splines ripping out / springs jumping out of these clutches , they're not lasting more than 2 months . i...

im getting a miss fire ONLY on idle , no white smoke , no backpressure , pistons are forged with trd head gasket and car was tuned to 20psi on 95RON , experienced some slight audible knock last night and car drove well home , only this morning i noticed a change in idle , plugs , wires and...

help in obtaining one is much appreciated .. the e6x is set for sequential injection and uses the stock triggering and ignition system on the 4efte thanks in advance:)

im building a 5efte and using a t3/t4 turbo on it .. goal of 300whp.... the purpose is to have the car running in the 12s bracket on toyo RA1s im thinking of installing a 4age 5 speed Gear box. im hoping that the close ratios will keep the engine revs in the 'sweet spot' thus using...

any one using these in the ep82? how do they perform on the engine? any problems tuning and running at least 25psi of boost ?

ive got a 4efte and '5ehfte' how much power can each of these stock rods withstand safely ?