People running over 300bhp, what clutch and flywheels are you running? My clutch and flywheel are shot and need a good upgrade. What do you recommend, how much, and where to get them? cheers
Hi guys. i used to have a set of trd coilovers but the common thing happened and the rears leaked. so now i have a set of d2s but they have always felt a bit soft. will it be ok to put the trd springs on the d2 shocks because i know the trd's are a stiffer srping rate, or am i going to ruin the...
After rotating a td04 how do you seal the wastegate shut for the use of a ex w/gate?Ive been told its not a good idea to weld it shut because its cast? cheers adam
Are any of using one of these rads with a universal slim fan? If so what are you using to mount the fan to the rad? pictures would be great to? cheers adam
hi guys. im after the outlet that points towards the passenger wing on the thermostat housing that the bottom radiator hose goes to. cash waiting! need one urgently
is there a oil seal behind the crankshaft pulley? i know there was one behind the flywheel on the other side of the engine, but is there one on the timing belt side behind the bottom pulley? cheers lads
this may be in the wrong section. but i was wondering if any of the traders would be able to look into getting polly bush kits for rear axle mounts and wishbone bushes? cheers adam
areet. i done the head gasket on my car and its a little bit tappy from the top end now. nothing major, just as if the tappets were worn but i know they dont have tappets. so is there anything i can do? cheers adam
just done the head on my car and now its sounds a litle bit like the inlet came is rattling. i heard some1 mention that the came needs tensioned down. wot is ment by tentioned? any1 had this problem? cheers adam
not sure how to put a link up. but there are some of these civic dual core rads on ebay and they are $45. just wondering if anyone knew if they are any good and will they be better than our stock rad. thanks for any feedback
this might sound stupid guys. but how do i stiffin my d2s. the fronts are quite low nd wen i corner they scrub like a bitch. do you turn the adjuster on the top of the strut if so wot way? clockwise(h) or anti(L) cheers lads
as it says in the title. how much is one of these worth? its red very clean bodywrk nd underneath but its done 120000miles. it ran sweet nd the interior was smart. so how much u think?
i think my head gasket has gone its pushing water out the rad put the car runs perfect. i want the head pressure tested then skimmed but ppl say this will highten my compression. what head gasket do you recommend? dealer or some kind of uprated like 1.2 or thicker? cheers